Product Overview:

LoRaWAN-BGGAThe Type Gateway is a product launched by Bogao Information CompanyLoRaWANExpand communication gateway to supportLoRaWANCommunication standards, implementationLoRaPhysical layer functionality, supportsMoteUpstream mode, and forward corresponding data according to specifications, can access various typesLoRaNode, supports Bluetooth configuration management, supports high-precision clock synchronization, to achieve low cost/Laying the foundation for low-power positioning,IP65Protection level, meets-40arrive70Outdoor industrial grade equipment with a wide temperature range of ℃ and resistance to harsh environments.

Functional features:

Adaptive wireless communication rate;

Automatic adjustment of transmission power;

Following standardsLoRaWANCommunication protocol;

Automatic network access and intelligent frequency hopping;

Realize data transmission, monitoring or intelligent management;

Ultra long communication distance and fast network access speed;

Low power design, energy-saving and environmentally friendly.

Communication data forwarding to increase coverage;

Support Bluetooth configuration management;

Performance parameters:

Working frequency:CN470MHz/AS923MHz/EU868MHz

Bluetooth:2.0+、2.4GHz

Wireless reception sensitivity:-146dBm

Wireless transmission power:Max +27dBm

LoRaAntenna type:N-Female interface

Bluetooth antenna type:T-NCFemale interface

Supply voltage:AC 220V

Working temperature:-40℃～+70℃

Whole machine power consumption:Max 10W

Waterproof grade:IP65

Shell material: AluminumADC12

External dimensions:162.2mm×142.6mm×83mm

Installation method: wall mounted

Working principle diagram:

Note: When the communication quality between the gateway and a small number of nodes is poor, a blind gateway can be used to relay the signal(haveLoRaWANagreement)And in the same situation, the cost advantage of adding a blind gateway is more obvious.

Installation steps:

1.Select installation environment and location

Based on the actual deployment environment, select the location where the blind patch gateway needs to be installed.

2.Install expansion screws

Based on the screw holes on the four fixed feet of the blind gateway, drill four expansion screws on the fixed surface,Ensure that the expansion screws are securely fastened, and the depth of the installation holes on the wall must be greater than50mm.

3.Install input power cord

Use an Allen wrench to open the cover of the blind repair gateway chassis, loosen the waterproof connector of the power supply, and connect the power cord fromConnect the wiring terminals inside the module through the headL\\NConnect the ground wire to the grounding hole of the circuit board, and finally tighten itTight waterproof joint.

4.Install antenna

installLoRaFiberglass antenna and Bluetooth fiberglass antenna.

Interface Description:

Transportation and Storage:

1.Transportation and unpacking should not be subjected to severe impacts, and should be carried out according toGB/T15464-1995According to the General Technical Conditions for Instrument Packaging, transportation and storage are required.

2.If there are obvious signs of damage to the casing due to severe impact or falling from a high altitude during handling, retrieval, or installation, please do not power on and contact the supplier as soon as possible.

3.Storage should be done in the original packaging, at an ambient temperature of-50℃～+80℃, with an average relative humidity not exceeding75%There are no corrosive gases in the air.

4.Stored in the warehouse, it should be placed on a shelf with a stacking height not exceeding10Box.