Instrument Introduction:

HG-HWP series constant humidity and temperature incubatorControlled by a microprocessor, it has functions such as monitoring, temperature control, and protection. Interior lighting: can observe the culture inside the box, stainless steel inner liner,

instrumentcharacteristic:

1The outer box of this equipment is made of cold-rolled steel plate, and the surface is coated with electrostatic spraying technology. The inner box is made of stainless steel, and the insulation layer is formed by polyester foam. The transparent window uses double-layer hollow glass to ensure the insulation performance inside the box (low-temperature incubator and...)BODThe stainless steel incubator is required to have no glass windows, and the box body has cold and hot air ducts to ensure smooth gas circulation and more balanced temperature.

2Unified adoption“Zero crossing”Contactless switch circuit technology enables pulse width modulation heating and cooling, resulting in a temperature control fluctuation range smaller than0.5℃The internal non-uniformity is1.0℃about.

Usage：

1Usage conditions:

AEnvironmental temperature:10-30℃

BNo strong corrosive gases, good ventilation, relative humidity85%below

CUsing power supply:220V±10%、50HZCapacity not less than1KWThere is a good grounding wire.

2Usage:

ABefore use, place the ultrasonic atomizer next to the machine, add water to the ultrasonic atomizer, connect the gasification pipeline, and plug the power cord of the ultrasonic atomizer into the three wire socket on the right side of the box

BStop humidifying when this machine is heating up

matters needing attention:

1. Attention should be paid to adding water in a timely manner when using a humidifier, according to the humidity requirements1-2Add water once a day to prevent damage. When adding water, remove the power plug of the humidifier, take off the humidifier water storage tank, turn it up counterclockwise to open the water sealing port, add water, then tighten the seal tightly, put it on the humidifier, and press the humidifier power on.

2. After the equipment lands, if the ground is uneven, it should be leveled with a cushion.

3. The general movement of the device should be parallel, and any tilt in any direction should be less than45Degree.

①When this device is operating normally, the placement of the contents inside the box should not affect air circulation to ensure uniform temperature inside the box.

②The inner lining of the box wall and the surface of the equipment should be regularly wiped to maintain cleanliness.

4. If not in use for a long time, the power cord should be disconnected to prevent the equipment from being charged and causing injury, and it should be operated regularly (usually quarterly) according to the usage conditions2-3Tian, to expel moisture from electrical components and avoid damaging related devices.

5. Professional personnel or manufacturers repair and solve the problem.