PH-110 industrial pH meter is an intelligent upgraded product of industrial acidity meter, which can continuously measure and control the pH value of sewage in real time. This device is suitable for water plants, factories, urban sewage treatment plants, chemical industry, printing and dyeing, papermaking, pharmaceuticals, electroplating, and environmental protection fields.

Industrial online pH meter

Characteristics of Industrial Online pH Meter Electrode:

1. Adopting internationally advanced solid dielectric and large-area polytetrafluoroethylene liquid interface, it is not easy to block and easy to maintain

2. The long-distance reference diffusion pathway greatly extends the service life of the electrode in harsh environments

3. Adopting PPS/PC shell, with upper and lower 3/4NPT pipe threads, easy installation, no need for sheath, saving installation costs

4. The electrode adopts high-quality low-noise cable, which can make the signal output length greater than 40 meters without interference

5. No need to supplement dielectric, low maintenance required

6. High measurement accuracy, fast response, and good repeatability

7. Ag/AgCL reference electrode with silver ions

8. Long service life with correct operation

9. Can be installed laterally or vertically in reaction tanks or pipelines

10. The electrode can be interchangeable with similar foreign electrodes.

Industrial online pH electrode

Industrial online pH meter electrode usage and maintenance

1. There is an appropriate amount of 3.3 M KCL solution in the protective bottle at the front end of the electrode. The electrode tip is soaked in it to maintain the activation of the glass bulb and liquid interface. When measuring, loosen the protective bottle, remove the electrode, and rinse with deionized water before use.

2. Before measurement, attention should be paid to throwing away the bubbles inside the glass bubble, otherwise it will cause measurement errors. During measurement, the electrode should be stirred in the test solution and placed still to accelerate the response.

3. Check if the joint is dry and clean. If there is any contamination, use anhydrous alcohol to wipe it clean and blow dry before use.

4. It is recommended to use the two-point method to calibrate the electrode, usually by first calibrating the position with pH 6.86 buffer solution, and then determining the slope with pH 4.01 or pH 9.18 buffer solution.

5. After use, clean the electrode and insert it into a protective bottle, then tighten the bottle cap to prevent the solution from leaking out.

6. The electrode should be cleaned regularly. If the electrode glass bulb is contaminated with the PTFE ring liquid interface, the following reagents can be used for cleaning. a. Surface active agent cleaning. b. Calcium precipitates or metal hydroxides can be cleaned with 10% dilute hydrochloric acid. c. Sulfide precipitation can be cleaned with 10% dilute hydrochloric acid. d. Protein attachments can be cleaned with a mixture of 10% dilute hydrochloric acid and pepsin.

Precautions for using industrial online pH meter

1. Please do not directly put the pH electrode into water. Instead, use an electrode mounting bracket or flow ring. (Suitable for submerged or flow-through installation)

2. Before installation, please make sure to use the raw material tape (3/4 thread) to ensure waterproof sealing and prevent water from entering the pH electrode, which may cause a short circuit in the pH meter electrode cable.

3. After connecting the electrode to the instrument, please preheat the instrument for 30 minutes before performing calibration work.

When performing electrode calibration work, attention should be paid to not placing the electrode flat, but vertically in the standard solution. Please place the glass bulb of the electrode facing downwards to prevent deviation of the MV data of the electrode.

6 installation methods for industrial online pH meters:

1. Side wall installation 2 Top flange installation 3. Pipeline installation

4. Top plug installation 5 Submerged installation 6. Flow installation