1、 Scope of application

HL30-100 isolation switch（HL30 small isolation switch）Suitable for distribution and control circuits with AC 50Hz or 60Hz, rated operating voltage of 230V or 400V and below, for no-load switching between the upper part of the 100A distribution device and the power supply. Mainly used as the main switch for terminal appliances, it can also be used to control various types of motors, low-power appliances, lighting, and other places. The mechanical and electrical lifespan is 10000 times, of which the electrical lifespan is 6000 times.
HL30 small isolation switchMeets the requirements of standards such as GB14048.3 and IEC947-3.

2、 Model and specifications

3、 Operating environment and working conditions

The ambient air temperature ranges from -5 degrees Celsius to+40 degrees Celsius, with an average temperature not exceeding+35 degrees Celsius.
The altitude shall not exceed 2000m.
The relative temperature of the atmosphere plus 40 degrees Celsius does not exceed 50%, and the wettest month is 90%.
The pollution level is level II.
◆ Use category AC-22A.
The installation form adopts TH35-7.5 steel installation rail installation, and the other installation surfaces have a vertical inclination angle of not more than five degrees with the body.

4、 Structural characteristics

The HL30 small isolation switch contact system adopts a double break direct acting structure, and two sets of parallel and contact connections are selected for high current, which not only increases the current capacity but also fully utilizes the electric force compensation. At the same time, the spring energy storage of the handle operating mechanism enables rapid switching. Overcoming the impact of slow manual operation speed, greatly improving the possibility of work, the contact opening and closing status has a prominent package label display, which can prevent misoperation and improve safety.

5、 Main technical parameters

Rated current (A)	32, 63, 100
Polar number (P)	1. 2, 3, 4
Rated working voltage (V)	Single phase 230
	Three phase 400
Rated short-time withstand current	12le， The power on time is 1 second
Rated short-time making capacity	20le， The power on time is 0.1s
Rated connection and disconnection capacity	3le, 1.05Ue, cos φ=0.65
Operational performance	No load 8500 times, load 1500 times, a total of 10000 times

6、 Installation and use

Before installing the HL30 small isolation switch, check whether the switch matches the actual working conditions.
During installation, insert the installation rail according to the position shown in the diagram, push up the handle to connect, and the indicator sign is red; Pull down the handle to disconnect, and the indicator label is green.
The power supply inlet should be connected from above the switch, and the lower end should be connected to the outlet. The copper wire should be tightened and not loose or exposed outside the terminal.
Before powering on, manually operate the switch several times, which should be flexible, reliable, and free of obstruction.
The HL30 miniature isolation switch must not be affected by rainwater during use, storage, transportation, and other processes.
The HL30 small isolation switch can withstand (short-circuit) currents under abnormal circuit conditions for a certain period of time, and can also withstand appropriate overloads without frequent switching, but cannot be used to disconnect fault currents.

7、 Appearance and installation dimensions

8、 Ordering Notice

When placing an order, please indicate the following points:
Product model and name: such as HL30Small isolation switch
Rated current: 100A.
Polar number: 3P
Order quantity: such as 8888 pieces.
Example of ordering: HL30Small isolation switch， 100A，3P， 777 pieces.